Presentations
Here is my starter presentation that was made part way through making my project. This was one of the initial presentations that was made and I still didn't know completely on how to make the LED Stroboscope.
Here is a selection of presentations I did throughout the semester and gave to the class.
Here is the final presentation I gave on the LED Stroboscope. This was given at the end of the semester when most of my plans were finalized for the LED stroboscope.
Below is an attachment that takes you to the user manual I made for my product. It gives a thank you, instructions on how to use it, and a section pertaining to how the circuitry and other parts of the project work.
This is a short video showing the OLED working with the Arduino Nano on the board to prove that it will work on the board.
Below are some videos with short descriptions of what is happening in each of them.
This is me showing off the code that will make the Arduino Nano blink the LEDs that I use in my circuit.
The link below will take you to a youtube video of me showing off the full circuit working. At this point there is no code and just the blinking lights with the 555-timer.
This is the Final video of the project that I took. I didn't end up getting it to work on the OLED display and ended up still getting the RPM's off of the console window.
In the video link below I connected code to the Arduino Nano and ran it. This code wouldn't display the RPM on the OLED but would show up in a console window on the Arduino Nano coding window.